Ban to Visit(禁访)
发帖新手
Remove the LCD and replace with the new one (if applicable). If you are replacing the LCD only you do not need to go any further than this stage. Reverse what you've just done for reassembly
Remove 4 Phillips screws circled below
Lift the metal plate to allow access to two more torx screws, circled below. Remove the ribbon which is attached to the back of the metal plate (shown held below) to access to rest of the phone. It is held on with double sided tape or glue and simply peels off
Remove the two torx screws circled below then run your finger along the edge of the housing to separate it from the rest of the phone
Slide the ribbon through the housing so you can remove this part of the housing
Remove the circuit board from the back part of the housing. It is held in by clips the run around the edge of the housing so pull the housing outwards in order to release the circuit board
查看详细资料
TOP
大闹天宫
贡献会员
发帖熟手
★花果山一哥★
LEVEL 3(初级探险者)
LEVEL 2(新手出村)
发帖学徒
原帖由 apple20 于 2007-3-7 09:14 PM 发表 楼主太有才了,看不懂。
军师
LEVEL 8(卓越品质)
发帖初学者
公告:服务器迁移已顺利完成! 网址全面启用 https 服务器2号 | 服务器3号 | 服务器4号 | 服务器5号 申请VIP无广告,支付宝,微信,USDT! 在线客服(1) (2) (3) (4) (5) (6) (7) (8) (9) 实时开通
服务器2号
申请VIP无广告,支付宝,微信,USDT!